25. After installing the Roland VSC, I get a "Cannot load VSCAPI.DLL" error at bootup.

The file VSCAPI.DLL needs should be copied to the \Windows\system32 folder (WINNT\system32 on Windows 2000) by the VSC installer. Most likely, you have some other software running on your computer that prevented this from happening. You can resolve the problem by doing the following:

  1. Uninstall the VSC using the Add/Remove Programs utility.
  2. Go to the Start menu and click on Run.
  3. Type msconfig and press OK.
  4. Choose 'Selective Startup', and uncheck 'Load Startup Items'.
  5. Press Apply, then press Close, and reboot the computer.
  6. Once the computer has restarted, cancel the System configuration Utility (if it comes up automatically), and install the VSC.
  7. After you have installed the VSC, set Windows back to 'Normal Startup' and reboot your computer again.

Note: Windows 2000 doesn't have the system configuration utility so you would need to close programs manually.



Alyssa - PG Music